Filter
Top Products
6 ► EP30200 / EP30250 User Manual
WARNING
Make sure battery charging is only accomplished in a
well ventilated room. DO NOT PLACE THE CONTROL
BOX ON TOP OF THE BATTERIES. REMOVE THE
BATTERY BOX COVER. Battery charging produces
explosive gases. A battery explosion can cause serious
injuries. Avoid battery explosions by keeping cigarettes,
sparks, and ames away from batteries being charged.
Always wear safety glasses when working with
batteries.
1. The three batteries furnished are sealed, maintenance
free batteries.
Sealed, maintenance free batteries do not contain cell caps
and are already lled with battery acid. They will require
charging before use.
NOTICE
Use only battery charger specially made for pin brazing
units (36V dc) approved by Stanley.
2. Locate the four battery cables and connect them to the
terminals on the batteries and the battery box as shown in
gure 1. Do not replace the lid on the battery box at this time.
Figure 1. Battery cable and terminals
3. Insert the enclosed foam-rubber spacers between each
battery and at both ends between the battery and the unit.
4. Connect the battery charger to the grinder outlet on the
unit, then to the mains. When removing the charger remove
the main rst, the remove the plug from the unit.
GENERAL PROTECTION
Store the Electronic Pin Brazing Unit in a place where it is
protected from the elements, abrasive dust, and damage.
Use only recommended repair and replacement parts and
materials specied in the Parts List section of this manual.
Use only recommended accessories also specied in the
Parts List section of this manual.
Do not use the Electronic Pin Brazers for applications it was
not designed for.
Use the carrying handle to transport the unit from location
to location.
CLEANING
Establish a routine to keep the unit as free from dirt as pos-
sible – daily, or at each shift change, for example.
Pin Brazers exposed to rain, sand, or grit-laden air should be
cleaned prior to each use.
Keep tool labels and stickers legible.
PREOPERATION PROCEDURES
Before putting a new Pin Brazer into initial service, or after an
extended period of being unused, perform a visual inspection
for bent, broken, cracked, missing or worn components.
INITIAL SETUP AND BATTERY CHARGING
WARNING
Failure to follow the instructions in the battery charger
operation manual can result in battery explosion and
serious bodily injury. To reduce the risk of battery ex-
plosion, read and understand the safety and operation
instructions in the battery charger operation manual,
the instructions published by the battery manufacturer,
and the instructions in this manual before attempting to
charge the batteries.
+Pos.
-Neg.
EP30200 OPERATION