Filter
Top Products
6 ► HGE12 User Manual
e) Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts and
any other condition that may affect the power
tool’s operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits,
etc. in accordance with these instructions, taking
into account the working conditions and the work
to be performed. Use of the power tool for opera-
tions different from those intended could result in a
hazardous situation.
5) BATTERY TOOL USE AND CARE
a) Recharge only with the charger specied by
the manufacturer. A charger that is suitable for one
type of battery pack may create a risk of re when
used with another battery pack.
b) Use power tools only with specically desig-
nated battery packs. Use of any other battery packs
may create a risk of injury and re.
c) When battery pack is not in use, keep it away
from other metal objects like paper clips, coins,
keys, nails, screws, or other small metal objects
that can make a connection from one terminal to
another. Shorting the battery terminals together may
cause burns or a re.
d) Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If contact
accidentally occurs, ush with water. If liquid
contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation or
burns.
6) SERVICE
a) Have your power tool serviced by a qualied
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
Additional Specic Safety Rules for Cordless
Rotary Grinder Tools
• Hold power tools by insulated gripping surfaces
when performing an operation.
WARNING: After changing bits or making any
adjustments, make sure the collet nut is securely
tightened to avoid injury.
WARNING: Do not press spindle lock or collet
lock buttons while motor is running. The operator
may lose control and drop the tool. Personal injury or
serious tool damage may result.
CAUTION: Do not touch the bit or collet nut dur-
ing or immediately after cutting material. The bit and
collet nut may be hot enough to burn bare skin.
• Do not run tool while carrying at your side. The
spinning bit may become entangled with clothing and
injury may occur.
• Always wear eye protection. Dust mask and
hearing protection must be used for appropriate
conditions. Using personal safety devices is recom-
mended. WORK SAFE.
• Do not use this tool with drill or screwdriver
bits. This tool is not intended to be used as a drill or
screwdriver.
• Be sure your cutting bits are sharp and in good
condition. Damaged bits can cause the tool to jump,
injuring the operator.
• Never touch the bit immediately after use. It may
be extremely hot.
• Be sure that the motor has stopped completely
before you lay the tool down. If the cutter head
is still spinning when the tool is laid down, it could
cause injury or damage.
• Be sure that the bit is clear of the work piece
before starting motor. If the bit is in contact with the
work piece when the motor starts it could make the
tool jump, causing damage or injury.
• If your tool fails to function properly, take it to
an authorized service center. There are no user
serviceable parts inside this tool and it should only
be opened by trained service personnel.
WARNING: ALWAYS use safety glasses.
Everyday eyeglasses are NOT safety glasses. Also
use face or dust mask if cutting operation is dusty.
ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
SAFETY PRECAUTIONS