Filter
Top Products
6
1.Open the magazine:
Pull pusher back to engage the latch.
2. Load Nails:
Hold nailer down with magazine tilted
downward.Insert stick of nails
3. Close Magazine:
Release pusher by first pulling back on the
pusher and then pressing the pusher release
tab. Slide pusher foreward against nails.
NOTE:Use only nails recommended for use in BOSTITCH Framing nailers or nails which meet the
BOSTITCH specifications.
LOADING THE N400S
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading,operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection.NOTE: Non-side shielded spectacles
and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while the air supply
is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
Pusher release tab.