Bostitch BTE140K Drill User Manual


  Open as PDF
of 28
 
4
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
•
Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and wash
exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust, which may
cause serious and permanent respiratory or other injury. Always use NOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles away
from face and body.
Symbols
The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts A ................... amperes
Hz ................hertz W ..................watts
min ..............minutes
or AC .......alternating current
or DC ...direct current
n
o .................no load speed
................Class I Construction .................earthing terminal
(grounded)
................safety alert symbol
................Class II Construction .../min or rpm...revolutions or
(double insulated) reciprocation per minute
...............
Read instruction manual before use
...................Use proper respiratory protection
................Use proper eye protection ................. Use proper hearing protection
BPM ............beats per minute
• When using an extension
cord,besuretouseone
heavy enough to carry the
current your product will
draw. An undersized cord
will cause a drop in line
voltage resulting in loss of
power and overheating.
The following table shows
the correct size to use
depending on cord length
and nameplate ampere
rating.Ifindoubt,usethe
next heavier gauge. The
smallerthegaugenumber,theheavierthecord.
FUNCTIONAL DESCRIPTION
Figure A
1.Variablespeedswitch
2.Lock-onbutton
3.Forward/reverseslider
4.Two-gearselector
5. Drilling mode selector
6.Chuck
7.Chuckkey&strap
8.Depthstoprod
9.Sidehandle
Minimum Gauge for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25 26-50 51-100 101-150
(0-7,6m)(7,6-15,2m)(15,2-30,4m)(30,4-45,7m)
240V 0-50 51-100 101-200 201-300
(0-15,2m)(15,2-30,4m)(30,4-60,9m)(60,9-91,4m)
Ampere Rating
More Not more American Wire Gauge
Than Than
0 - 6 18 16 16 14
6 - 10 18 16 14 12
10 - 12 16 16 14 12
12 - 16 14 12 NotRecommended
a
1
2
3
4
5
9
6
8
7
 previous next