Bostitch BTE140K Drill User Manual


  Open as PDF
of 28
 
5
Safety Warnings and Instructions: Drills
WARNING:
1.Holddrillfirmlywithonehandonthegripandtheother
hand on the side handle as shown in figure B.
2.Whenattachingaccessoriesinthedrillchuck,tighten
with all three holes to prevent slippage.
WARNING: Drillmaystall(ifoverloadedorimproperly
used)causingatwist.Alwaysexpectthestall.Gripthedrill
firmly with both hands to control the twisting action and
prevent loss of control which could cause personal injury. If
astalldoesoccur,releasethetriggerimmediatelyand
determinethereasonforthestallbeforere-starting.
Assembly
WARNING: Toreducetheriskofinjury,beforeassembly,
makesurethatthetoolisswitchedoffandunplugged.
Attaching the side handle - (figure C)
Ifyourdrillisequippedwithasidehandle,itmustbe
installed properly to control the drill
• Turnthegripcounterclockwiseuntilyoucanslidetheside
handle(9)ontothefrontofthetoolasshown.
• Rotatethesidehandleintothedesiredposition.
• Insertthedepthstop(8)intothemountingholeasshown.
• Setthedrillingdepthasdescribedunder“Settingthe
Drilling Depth.”
• Tightenthesidehandlebyturningthegripclockwise.Make
sure that the side handle is secure and does not slip.
Inserting a drill bit or other accessory
(figure D)
WARNING: Do not attempt to tighten drill bits (or
any other accessory) by gripping the front part of the chuck and turning the tool
on. Damage to the chuck and personal injury may occur when changing accessories.
WARNING: Always ensure the bit is secure before starting the tool. A loose
bit may eject from tool causing possible personal injury.
• Openthechuck(6)byturningthecollarcounterclockwise(whenviewedfromthechuckend).
• Inserttheaccessoryshaftintothechucktoabout3/4in.(19mm)depth,centeredinthejaws.
• Tightenchuckcollarbyhandbyturningthecollarclockwise.Placechuckkey(7)into
eachofthethreeholesandsecurelytighteninaclockwisedirection.
NOTE:Tightenchuckwithallthreeholestopreventslippage.
Operating Instructions
WARNING: To reduce the risk of serious personal injury, read, understand
and follow all safety warnings and instructions prior to using tool.
WARNING: It is important to support the work properly and to hold the drill
firmly with both hands to prevent loss of control which could cause personal injury.
WARNING: Do not attempt to tighten drill bits (or any other accessory) by
gripping the front part of the chuck and turning the tool
on. Damage to the chuck and personal injury may occur
when changing accessories.
WARNING: To reduce the risk of injury, always
unplug drill from power supply before making any
adjustments or changing accessories.
WARNING: To reduce the risk of injury, let the tool
work at its own pace. Do not overload.
Selecting the drilling mode (figure E)
• Fordrillinginmasonry,setthedrillingmodeselector(5)to
the“hammersymbol”
position.
• Fordrillinginothermaterialsandforfastening,setthe
drillingmodeselector(5)tothe“drillsymbol”
position.
B
c
5
2
3
1
4
d
e
 previous next