Filter
Top Products
-6-
Tool Model Fastener Type Fastener SKU Crown Width Gauge Length
BTFP12233
BT1300
N/A
18 5/8”(15mm)
BT1303
N/A
18 3/4” (19mm)
BT1309
N/A
18 1” (25mm)
BT1332
N/A
18 1-1/4” (32mm)
BT1338
N/A
18 1-1/2” (38mm)
BT1340
N/A
18 1-9/16” (40mm)
BT1345
N/A
18 1-3/4” (45mm)
BT1350 N/A 18 2” (50mm)
Brads
TOOL SPECIFICATIONS
All dimensions in inches unless otherwise specified.
BTFP12233
Description 18 GA Brad Nailer
Engine Type Oil-Free
Operation Pressure Range 70-120 PSI (4.9 to 8.43kg/cm
2
)
Maximum Operation Pressure 120 PSI (8.43 kg/cm
2
)
Fastener Type BT13XX Series
Fastener Gauge 18 Gauge
Fastener Range 5/8” - 2-1/8” (15mm-55mm)
Magazine Capacity 100
Length 11.3” (287mm)
Width 3.2” (81mm)
Height 9.5” (241mm)
Weight 3.1lbs. (1.4kg)
Operating Pressure:
70 to 120 p.s.i.g. (4.9 to 8.43 kg/cm
2
). Select the operating pressure within in this range for best fastener
performance.
Air Consumption:
The BTFP12233 requires 1.15 cubic feet per minute or C.F.M. (32.6 liters per minute or LT/MIN) of free air
at 80PSI (5.6 kg/cm
2
) to operate at a rate of 60 fasteners per minute. To determine the appropriately sized
air compressor, take the actual rate at which the tool will be run and compare the required C.F.M. (LT/MIN)
to the compressors free air delivery (C.F.M./ LT/MIN) at 80 PSI (5.6 kg/cm
2
).
For example, if your fastener usage averages 30 fasteners per minute, you need 50% of the tools C.F.M.
required to operate the tool at the rate of 60 fasteners per minute. In this case, be sure that your air
compressor can deliver a minimum of 0.58 C.F.M. (16.4 LT/MIN) at 80 PSI(5.6 kg/cm
2
) for optimum
performance.
FASTENER SPECIFICATIONS
* Stainless steel fasteners also available in certain sizes. Visit www.BOSTITCH.com for further details.
NOTE:
BOSTITCH tools have been engineered to provide superior customer satisfaction and are designed to achieve
maximum perfomance when used with precision BOSTITICH fasteners engineered to the same exacting
standards. BOSTITCH cannot assume responsibility for product performance if our tools are used with
fasteners or accessories not meeting the specific requirements established for genuine BOSTITCH
fasteners and accessories.
DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.