Filter
Top Products
-5-
TOOL OPERATION
EYE PROTECTION which conforms to ANSI specifications and provides protection against flying particles both from the
FRONT and SIDE should ALWAYS be worn by the operator and others in the work area when connecting to air supply,
loading, operating or servicing this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection equipment must conform to the
requirements of the American National Standards Institute, ANSI Z87.1/CAN/CSA Z94.3 and provide both frontal and side
protection. NOTE: Non-side shielded spectacles and face shields alone do not provide adequate protection.
BEFORE HANDLING OR OPERATING THIS TOOL:
READ AND UNDERSTAND THE WARNINGS CONTAINED IN THIS MANUAL.
BOSTITCH OFFERS ONE TYPE OF OPERATION FOR THE BTFP71875 SERIES TOOLS, TRIGGER OPERATION WITH SECONDARY TRIGGER
OPERATION
TRIGGER OPERATION WITH A SECONDARY TRIGGER:
When the secondary trigger is pulled, the tool will actuate each time the trigger is pulled. This trigger operated tool is operated by first pulling or grasping
the secondary trigger under the hand grip, followed by pulling the trigger under the valve as shown Fig. 5.
Never inadvertently pull or grasp the secondary trigger when moving about, changing work location, when holstering or
hanging tool, or when preparing work surface for fastening operation.
The operator must not hold the secondary trigger pulled except during fastening operation as serious injury could result
if the trigger accidentally contacts someone or something, causing the tool to cycle.
FASTENER JAM CLEARING
ALWAYS DISCONNECT THE TOOL FROM AIR SUPPLY BEFORE CLEARING A JAMMED FASTENER.
TO CLEAR A JAMMED FASTENER:
1. Release the magazine and pull it back.
2. Remove Jammed fastener
USING THE OPTIONAL BELT HOOK (SOLD SEPERATELY)
Always disconnect tool from air supply when making adjustments or servicing.
The operator must not hold the secondary trigger pulled except during fastening operation as serious injury could result if the
trigger accidentally contacts someone or something, causing the tool to cycle.
Never inadvertently pull or grasp the secondary trigger when moving about, changing work location, when holstering or hanging
tool, or when preparing work surface for fastening operation.
TOOL OPERATION CHECK:
Remove all fasteners from tool before performing tool operation check.
TRIGGER OPERATION WITH A SECONDARY TRIGGER:
The trigger will only actuate the tool if the secondary trigger has already been pulled.
The secondary trigger is located under the handle. The secondary trigger prevents the primary trigger from actuating the tool if
the secondary trigger has not been pulled first.
PULL OR GRASP THIS SECONDARY
TRIGGER FIRST
PULL TRIGGER
Fig.5