Filter
Top Products
4
All dimensions in inches unless otherwise specified
MFN-201
D
escription Manual Flooring Nailer
F
astener Type “L”Type 16 Gauge Flooring Cleats
Magazine Capacity 120 cleats
Length 13-7/16” (340mm)
Width 3-1/2” (89mm)
Height 17-1/2” (444mm)
Weight 8.6 lbs (3.9kg)
Tool Model Fastener Type Fastener SKU Gauge Length
MFN-201 Manual FLN-150 16 1-1/2”
Flooring Nailer FLN-200 16 2”
NOTE:
BOSTITCH tools have been engineered to provide superior customer satisfaction and are
designed to achieve maximum performance when used with precision BOSTITCH fasteners
engineered to the same exacting standards.
BOSTITCH cannot assume responsibility for
product performance if our tools are used with fasteners or accessories not meeting the
specific requirements established for genuine BOSTITCH fasteners and accessories.
MFN-201 TOOL SPECIFICATIONS
MFN-201 FASTENER SPECIFICATIONS
TOOL SETUP
The MFN-201 was designed to install 1/2” to 3/4” tongue and groove hardwood flooring.The tool is factory set for
3/4” flooring.Two additional f
oot plates are included with this tool to accommodate 1/2”
and 5/8” flooring.
Flooring products will vary and the user must ensure the tool is properly adjusted each time
flooring is being installed.
Dimensions listed on the footplates are suggestions.Test fastener
placement on scrap pieces of wood bef
ore installing floor.
To change footplates:
1.Remove 4 flat head cap screws.
2.Change to desired plate.
3.Replace 4 flat head cap screws.
FASTENER PLACEMENT:
Too High Correct Too Low
Flat head
cap scre
ws