Filter
Top Products
-6
EYE PROTECTION which conforms to ANSI specifications and provides
protection against flying particles both from the FRONT and SIDE should
ALWAYS be worn by the operator and others in the work area when loading,
operating or servicing this tool. Eye protection is required to guard against
flying fasteners and debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye
protection equipment must conform to the requirements of the American National
Standards Institute, ANSI Z87.1-1989 (R1998) and provide both frontal and side
protection. NOTE: Non-side shielded spectacles and face shields alone do not
provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool
while the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
•Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
LOADING THE N100S
1.Open the magazine:
Pull pusher back to engage latch.
2. Load Nails:
Hold nailer down with magazine tilted
downward. Insert sticks of nails
3. Close Magazine:
Release latch by pulling latch tab
and pusher together slightly to
disengage, slide pusher against
nails.
NOTE: Use only nails recommended for use in Bostitch N100S series nailers or nails which meet the
Bostitch specifications