Filter
Top Products
-4-
TOOL SPECIFICATIONS
All screws and nuts are metric.
FASTENER SPECIFICATIONS:
TOOL MODEL BRAD SERIES GAUGE FASTENER RANGE
SB-125BN BT1300 18 5/8” - 1-1/4”
SB-1842BN BT1300 18 5/8” - 1-5/8”
SB-1850BN BT1300 18 5/8” - 2”
SB-2 IN 1 BT1300 18 5/8” - 1-5/8”
TOOL MODEL STAPLE SERIES CROWN WIDTH FASTENER RANGE
SB-150SX SX5035 5-6mm 1/2” - 1-1/2”
SB-2 IN 1 SX5035 5-6mm 1/2” - 1-1/2”
TOOL MODEL NAIL SERIES GAUGE FASTENER RANGE
SB-1664FN SB16 16 1” - 2-1/2”
TOOL AIR FITTING:
These tools use a free-flow connector plug, 1/4 N.P.T. The inside diameter should be
.200” (5mm) or larger. The fitting must be capable of discharging tool air pressure when
disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i.g. (4.9 to 7.0 kg/cm
2
). Select the operating pressure within this range for
best fastener performance.
DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
OPERATION
BOSTITCH OFFERS TWO TYPES OF OPERATION.
CONTACT TRIP
The common operating procedure on “Contact Trip” tools is for the operator to contact the work to actuate
the trip mechanism while keeping the trigger pulled, thus driving a fastener each time the work is
contacted. This will allow rapid fastener placement on many jobs, such as sheathing, decking and pallet
assembly. All pneumatic tools are subject to recoil when driving fasteners.The tool may bounce, releasing
the trip, and if unintentionally allowed to recontact the work surface with the trigger still actuated (finger
still holding trigger pulled) an unwanted second fastener will be driven.
SEQUENTIAL TRIP
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This
makes accurate fastener placement easier, for instance on framing, toe nailing and crating applications.
The Sequential Trip allows exact fastener location without the possibility of driving a second fastener on
recoil, as described under “Contact Trip”.The Sequential Trip Tool has a positive safety advantage because
it will not accidentally drive a fastener if the tool is contacted against the work – or anything else – while
the operator is holding the trigger pulled.
MODEL IDENTIFICATION:
Refer to Operation Instructions on page 9 before proceeding to use this tool.
CONTACT SEQUENTIAL
TRIP TRIP
Identified by: Identified by:
BLACK GRAY
MODEL TOOL ACTUATION LENGTH HEIGHT WIDTH WEIGHT
SB-1842BN Sequential Trip 9.25” 8.5” 2” 2.38 lbs.
SB-1850BN Sequential Trip 9.25” 9.5” 2” 2.69 lbs.
SB-150SX Sequential Trip 9.50” 8.75” 2” 2.65 lbs.
SB-1664FN Sequential Trip 11.25” 11.50” 3” 4.03 lbs.
SB-125BN Sequential Trip 9.25” 8” 2” 2.12 lbs.
SB-2IN1 Sequential Trip 9.25” 8.5” 2” 2.38 lbs.