D16-2AD
BOXLOK STAPLER
STAPLE SIZES: SW7437 7/16 SW7437 5/8 SW7437 3/4
SW9040 5/8 SW9040 3/4 SW9040 7/8
Stanley Fastening Systems
BEFORE OPERATING THIS TOOL, ALL OPERATORS SHOULD STUDY THIS MANUAL TO UNDERSTAND
AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS. KEEP THESE INSTRUCTIONS WITH
THE TOOL FOR FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS, CONTACT YOUR BOSTITCH
REPRESENTATIVE OR DISTRIBUTOR.
DO NOT USE SUPPLY SOURCES WHICH CAN POTENTIALLY EXCEED 80 PSIG (5.7 KG/CM2) AS TOOL
MAY BURST, POSSIBLY CAUSING INJURY.
WHEN AIR SUPPLY .IS CONNECTED KEEP HANDS AND BODY AWAY FROM STAPLE DISCHARGE AREA
AT ALL TIMES. DO NOT FIRE THE TOOL WITHOUT STAPLING INTO MATERIAL.
THE CONNECTOR ON THE TOOL MUST NOT HOLD PRESSURE WHEN AIR SUPPLY IS
DISCONNECTED. IF A WRONG FITTING IS USED, THE TOOL CAN REMAIN CHARGED WITH AIR
AFTER DISCONNECTING AND THUS WILL BE ABLE TO DRIVE A STAPLE EVEN AFTER THE AIR LINE
IS DISCONNECTED POSSIBLY CAUSING INJURY.
DO NOT PULL TRIGGER OR DEPRESS CONTACT ARM WHILE CONNECTED TO THE AIR SUPPLY AS
THE TOOL MAY CYCLE, POSSIBLY CAUSING INJURY.
DO NOT USE OXYGEN, COMBUSTIBLE GASES, OR BOTTLED GASES AS A POWER SOURCE FOR THIS
TOOL AS TOOL MAY EXPLODE, POSSIBLY CAUSING INJURY.
FAILURE TO OBSERVE ANY OF THESE WARNINGS MAY RESULT IN INJURY.
BSA981SREVE 9/03
OPERATION and MAINTENANCE MANUAL