Filter
Top Products
Requirements
• Servers. The Recovery Kit requires two or more supported computers
configured in accordance with LifeKeeper requirements described in the
LifeKeeper Release Notes, which are shipped with the LifeKeeper
product media.
• LifeKeeper software. You must install the same version of LifeKeeper
software and any patches on each server. Please refer to the LifeKeeper
Release Notes for specific LifeKeeper requirements.
• LifeKeeper IP Recovery Kit. You must have the same version of this
Recovery Kit on each server.
• IP network interface. Each server requires at least one Ethernet
TCP/IP-supported network interface. In order for IP switchover to work
properly, user systems connected to the local network should conform to
standard TCP/IP specifications.
Note: Even though each server requires only a single network interface,
you should use multiple interfaces for a number of reasons including
heterogeneous media requirements, throughput requirements, elimination
of single points of failure, network segmentation, and so forth.
• TCP/IP software. Each server requires the TCP/IP software.
• SAMS software. Each server must have the following SAMS software
packages (RPM format) installed:
• smiswitchgui (Sendmail Switch)
• smserver (Sendmail Advanced Message Server)
The same versions should be installed on each server. Consult the
LifeKeeper Release Notes or your sales representative for the latest
release compatibility and ordering information.
You should refer to the LifeKeeper for Linux Planning and Installation
Guide for specific instructions on how to install or remove the LifeKeeper
SAMS Recovery Kit.
6 SAMS Recovery Kit Administration Guide