Filter
Top Products
Page 8
SMC Series Chillers
1-4 Available Options
SMC Series Chillers are available with options that tailor the unit to your requirements. Some are
factory installed, some can be retrofitted in the field. Consult your local Sterlco Sales
Representative. Some of these options are:
Special Pumps
Special pump options are available for greater pressure and flow rates. Bronze and stainless steel
wetted surface standard flow pumps ranging from 30 psi (207 kPa) to 60 psi (414 kPa) are
available.
Reservoirs
SMC Series Chillers are available without a reservoir for processes that use their own reservoir.
Power Cord
A 10 foot (3 meter) power cord is available to speed SMC installation.
Casters
Four 2-inch (5 cm) swivel casters add mobility to the SMC unit.
CPR Valve
A crankcase pressure regulating (CPR) valve is available for leaving water temperatures up to
75°F (24°C).
1-5 Uncrating Your New Chiller
SMC Series Chillers are shipped mounted on a skid, enclosed in a plastic wrapper, and open
crated on all four sides and top.
; Pry the crating away from the skid and remove. Use a pry bar to remove the blocks securing
the unit to the skid.
; Lift the unit off the skid with a fork truck. Insert forks between skid and chiller from the side
until they protrude beyond the opposite side of the unit. The forks must be equidistant from
the center line of the unit and the unit must be balanced on the forks.
; Lift slowly and only high enough to clear the skid. Use a pry bar if necessary to remove the
skid from the unit.
; Lower slowly. The unit will land on its feet or casters and can be moved into position.