Filter
Top Products
Page 31
Step 1:
Fill the bin with granulate of the material you intend to run through
the granulator. Make sure the bin is filled to a level that covers the
front face of the latex sensor covering located on the rear wall of
the bin.
Step 2:
Make sure that power is supplied to the machine by turning the
main disconnect switch to the ON position and connecting the
control enclosure to the main power source.
DO NOT START THE MACHINE.
Step 3:
Locate the sensor on the rear wall of the machine base.
Using a small screwdriver, locate and turn the potentiometer
located on the rear face of the sensor.
• Turning the potentiometer clockwise (CW) increases sensitivity
and activates the alarm.
• Turning counterclockwise (CCW) decreases sensitivity and
shuts off the alarm.
With the bin in place, turn the potentiometer so that the alarm
sounds, then rotate counterclockwise (CCW) until the alarm just
goes off. Now rotate clockwise (CW) one-half to one ( ½ to 1)
turn.
The sensor is now set and the unit is ready to granulate new
material
5-6 Recommended Spare Parts List
A Recommended Spare Parts List is part of the operation and
installation package that arrives with your new machine. Look for
a Recommended Spare Parts List to find the specific part numbers
that pertain to the categories listed in Figure 2: Recommended
Spare Parts List Categories. The list in Figure 2: Recommended
Spare Parts List Categories reflects a general list of spare parts that
should be kept on hand to keep your new granulator running at
optimum performance.
Please keep the Recommended Spare Parts List in a place where
you can easily retrieve it. Please have the machine serial number