Filter
Top Products
XSV-05, XSV-05/R, & XSV-05/2R Single Conveying Units - Venturi Style 18of 36
This chapter is intended for the operating personnel of the
equipment.
General knowledge of operating conveyor units is required.
The functional description must be read and understood.
Make sure that in each case the operating personnel are
sufficiently informed.
Chapter 4: Setup
»
4-1 Preparations
Check to see if the venturi assembly is inserted in the material to be
conveyed.
Switch the compressed air supply ON at the compressed air source.
Switch the conveyor unit electrical switch ON at the control and maintenance
unit.
The conveyor unit should now convey until the conveyor hopper is filled up to the
level sensor.
4-2 Setting the Mixing Ratio of the Components (XSV-05/2R
Units)
The mixing ratio of the components is adjusted at the regulator. By changing the
regulator pressure of each material, you will adjust the rate at which each
material is conveyed into the conveyor hopper. This will determine the ratio of
two materials entering a conveyor hopper.
The adjustment of the regulator will vary according
to the material, flow properties, particle size and conveying
distance.