Tascam cg2000 Welding System User Manual


 
TASCAM CG-2000
23
7 – Operations using USB flash drives
Importing presets from USB flash
drives
Preset data exported to a USB flash drive can be imported to this
unit’s preset memory.
This can be done from the
UTILITY 2
page.
1. Press the MENU button repeatedly to open the
UTILITY
2
menu page, and turn the MULTI JOG dial to select the
PRESET IMP/EXPORT
item.
2. Press the MULTI JOG dial to open the
IMP/EXPORT
screen.
3. Turn the MULTI JOG dial to set the
MODE
to
IMPORT
.
4. Press the MULTI JOG dial to open the
IMPORT FROM
screen.
The preset and SYS ALL data saved on the USB flash drive
will appear in a list.
5. Turn the MULTI JOG dial to select the preset that you want
to import.
NOTE
Presets with the same numbers can be distinguished by their
dates and id numbers.
6. Press the MULTI JOG dial.
If you selected data for a preset on the USB flash drive, the
IMPORT TO
screen will open.
If you selected SYS ALL data, the import confirmation screen
shown in step 8 will appear (skip step 7).
7. If you selected data for a preset on the USB flash drive, turn
The MULTI JOG dial to select the preset number to which
you want to import that data.
Options: PRESET 1, PRESET 2, PRESET 3, PRESET 4
8. Press the MULTI JOG dial to open the import confirmation
screen.
When data for a single preset is selected
When SYS ALL is selected
9. Press the MULTI JOG dial to start importing from the USB
flash drive to this unit.
NOTE
Before pressing the MULTI JOG dial, press the EXIT/CANCEL
button to cancel importing and return to the menu screen.
10. After importing completes or is canceled, the unit will return
to the state shown in step 4.
Repeat steps 5 - 7 if you want to import additional preset
data.
CAUTION
After importing completes, preset data previously stored
will be overwritten. This procedure cannot be reversed.