Filter
Top Products
PMD8129 Models
Owner’s Manual
14. WARNING: Batteries vent hydrogen gas and may explode in the presence
of a source of ignition, such as a pilot light. To reduce the risk of serious
personal injury, never use any cordless product in the presence of an open
flame. An exploded battery can propel debris and chemicals. If exposed,
flush with water immediately for a minimum of 10 minutes and seek
medical attention.
15. During extreme conditions, the battery may leak. This does not indicate a
battery failure. However, if the liquid gets on your skin, immediately wash
with soap and water, neutralize the area with a mild acid such as lemon
juice or vinegar. If the liquid gets into your eyes, flush them with clean
water immediately for a minimum of 10 minutes and seek medical attention.
Symbols:
V ……................................................ volts
................................................. direct current
n
0
……............................................... no load speed
.../min ............................................... revolutions or reciprocation per minute
Hz …….............................................. Frequency
Ø ……................................................ Diameter
.......................................... Contains non-spillable nickel-cadmium
battery. Battery must be recycled or
disposed of properly.
FUNCTIONAL DESCRIPTION
SPECIFICATIONS for PMD8129
Voltage 18V DC
Speed 0-600RPM
Torque Settings 24 + Drill
Chuck Capacity up to 3/8”
Charger Input 120V AC 60Hz
Charging Time Approx. 3 –8 Hours
Battery Type Ni-Cd
ASSEMBLY
Controls and Components:
Batteries and AC Charger
1. Battery with Release Buttons On Each Side (1 pc)
2. 120V AC Adaptor
3. Charging Stand with LED Charging Indicators
Drill:
4. 3/8” Jacobs Keyless Chuck
5. 24 Adjustable Torque Settings Control Ring
6. Forward/Lock/Reverse Switch
7. High/Low Speed Switch (PMD8131 and PMD8133 only)
8. Variable Speed Trigger Switch
9. Accessory/Bit Holder
10. Comfort Rubber Grip (PMD8131 and PMD8133 only)
ACCESSORIES
11. 6 Various Screwdriver Bits
12. 2” Extension Bar
13. 2 Double Ended Screwdriver Bits
14. 6 Various Drill Bits
5 6
Ni-Cd
Ni-Cd
1
3
2
9
4
5
6
7
8
10
11
13
12
14