Filter
Top Products
8
Charging Batteries
1. With four rechargeable AA batteries installed in myPower GO, plug the adapter
with the black tip into the input/output cord.
2. Plug the adapter tip into the DC IN jack on the end of myPower GO.
3. Plug the USB plug on the opposite end of the input/output cord into a USB jack
on a computer. The green LEDs will light in sequence to indicate that the batteries
are being charged.
4. After 6 hours, unplug myPower GO. The batteries will be fully charged.
NOTE: It is strongly recommended to recharge the batteries only when completely
empty.
mp1500_ug_revB_r3 11/7/06 2:09 PM Page 8