Filter
Top Products
6
To Charge through the DC IN Port
1. Connect the solar panel output cable into the DC IN port on myPower ALL Plus.
2. Verify that the red charging indicator turns on to indicate the battery is charging and is less than 80%
charged.
3. When the charging indicator turns to green, press the Capacity Display button to view the battery
capacity. If the capacity does not indicate full (all green LEDs on), continue to charge the battery until
the battery capacity indicates full.
4. When the battery capacity indicates full, unplug the connected charging cable.
To Charge through the 3-Pin Input Port
1. Connect the 3-Pin end of the optional Smart 3-Pin Adapter
into the 3-Pin Input port on the MP3700 (shown) and the
other end into the solar panel output port.
2. Verify that the charging indicator next to the input jack on the
Smart 3-Pin Adapter (shown) will turn on to indicate the
battery is charging.
3. After approximately four hours, press the Capacity Display button
to view the battery capacity. If the capacity does not indicate full
(all green LEDs on), continue to charge the battery until the
battery capacity indicates full.
4. When the battery capacity indicates full, unplug the
connected charging cable.
LED turns on when solar panel is
charging myPower ALL Plus