Filter
Top Products
8
4. Wi-Fi Protected Setup (WPS) Push Button Setup
Note:
1: Wi-Fi Protected Setup (WPS) allows you to quickly connect to your wireless router or
access point.
2: Do not connect/install the TEW-687GA to your network until instructed to do so. Make
sure your network adapter settings are set to obtain an IP address automatically (see
troubleshooting section).
3. Press and hold the WPS button on your
wireless router or access point for 2 seconds.
The example shows a TEW-691GR.
1. Find a location where you would like to place
the TEW-687GA. The location must be within
the wireless coverage of your router or access
point. Please refer to the wireless tips sections
for additional information.
2. Connect the Power Adapter to the TEW-687GA
and then to a power outlet. (EU Versions will
have a power button on the back. Push the
power button to the “On” position. ). Wait 30
seconds for the TEW-687GA to boot up.