Filter
Top Products
5
Mounting
WARNING! Mount your Inverter/Charger BEFORE DC
battery and AC power connection. Failure to follow these
instructions may lead to personal injury and/or damage
to the Inverter/Charger and connected systems.
Tripp Lite recommends that you permanently mount your Inverter/Charger in the configuration
illustrated below. The APSX700HF features integrated mounting brackets at the front and rear of the
unit. The user must supply mounting hardware and is responsible for determining if the hardware and
mounting surface are adequate to support the weight of the unit. Read the Important Safety Instructions
section before mounting.
Using the measurements shown in the diagram, install two user-supplied fasteners , leaving the heads
slightly raised. Slide the unit over the fasteners to engage the mounting bracket slots . Tighten the
fasteners. Install two additional fasteners over the remaining mounting bracket.
C
B
A
4.31 in.
(10.95 cm)
10.93 in. (27.8 cm)
A
B
C
200705102 93-2678 APSX700HF OM.qxd 8/30/2007 12:34 PM Page 5