Filter
Top Products
3
ASSEMBLY & SET-UP
Main Parts & Controls
A. Lamp Head
B. Clamp Assembly
C. Metal Clamp Swivel
D. Lamp Tightening Knob
E. Power Cord
F. Polarized Plug
G. Parabolic Grid Diffuser
H. Bulb
I. High/Off/Low Switch
Read Instructions Carefully Before Set-up:
1. Remove lamp and packaging from box. Note: Please save original
packaging for repacking should you need to return the product.
2. Remove clamp and turn the clamp screw counterclockwise
until it is open slightly wider than the work surface to which
you are attaching it. Clamp fi ts fl at surfaces up to 2.25” thick.
Surface must be a minimum of 1.5” deep for clamp to hold
securely.
3. Slide the clamp onto work surface, and turn metal clamp
swivel clockwise to tighten securely.
4. Place lamp shaft into clamp assembly and turn tightening
knob (D) clockwise to secure.
5. Adjust upper and lower goosenecks as needed to illuminate
work surface.
6. Attaching the Parabolic Grid Diffuser
• Remove grid diffuser from protective plastic bag and remove all
styrofoam packing around bulb.
• Bulb may have loosened in socket during transit,
please press down to ensure it is fully seated.
• Insert plastic pegs at bottom of grid diffuser into
openings near bulb socket
• Snap tab into place
7. Plug lamp into outlet and turn on; if bulb does not
illuminate instantly, please refer to the troubleshooting
section of this manual.
A
B
E
F
D
C
D
G
I
H