Filter
Top Products
OPERATION
Before each use
CAUTION: Serious injury or death may occur if electrical sparks from motor and
pressure switch come in contact with flammable vapors, combustible dust,
gases or other combustible materials. When using the air compressor for spray
painting, place the air compressor as far away from the work area as possible.
Use extra air hoses instead of extension cords.
CAUTION: In order to avoid damaging the air compressor, do not incline the
air compressor transversely or longitudinally more than 10°.
Pre-Start Checklist
• Check pressure-hose for damages and replace, if necessary.
• Check all screwed connections for tightness and tighten, if necessary.
• Check power-cable for damages and have it replaced by service-station, if
necessary.
The compressor must operate only in dry environment.
Place air compressor at least 12 inches away from obstacles that may prevent
proper ventilation.
Place the power-cable in a way that it does not interfere your work and that it is
not damaged.
Before connecting the compressor to the power supply, always check the switch
is in position “OFF”. (see FIG. 1)
Protect the power-cable against heat, oil or sharp edges.
Always switch off the compressor by using the main-switch and do not stop by
unplugging.
After having finished your job, switch the compressor off and disconnect from the
power- supply
Start up (see FIG. 4 on page 12)
1. Check the switch is in the “OFF” Position.
2. Plug the power cord into the grounded outlet.
(see FIG. 1)
FIG. 1
3. Switch the compressor “ON” (pull switch up)
and wait; until the maximum tank pressure is
reached at 115 psi. (The motor will stop
automatically). The tank-pressure is indicated
on the tank pressure gauge.
11