Wagner SprayTech 290024 Impact Driver User Manual


  Open as PDF
of 72
 
PowrDriver 11
GB
Operation Checklist
Review the pre-operation check as follows:
a. Recheck that all components are correctly installed to insure
safe operation
b. Check engine oil.
c. Check Transmission oil.
d. Fill Fuel with non-leaded gas in tank.
e. Check tire pressure.
Start up:
Priortoputtingtheequipmentintooperation,pleasereadthe
instructions in the operating manual for Honda motors carefully
through.
1. InstallthetrailerhitchtothebackofyourLineCoatequipment
using the 8 screws.
2. HangthePowrDriverontheLineCoatequipmentandmake
sure that the hitch engages. Secure the hitch with bolt and
split.
3. Openthefuelvalve(PositionON)
4. When the motor is cold, place the choke lever in the CLOSED
position.
If the motor is already warmed up, place the choke lever in the
OPENposition.
5. Open the gas lever to maximum 1/3.
6. Adjustthegaspedalusingtheadjustmentleverifnecessary.
7. Step up on the step, and sit down on the seat.
8. Adjusttheseattoyourheightandlockitinplace.
9. Stick the key in the ignition on the right side of the seat, and
turn it until the motor starts. Let go of the key.
10. Turn the fan on with the toggle switch.
Attention
Danger of overheating. Always turn on the fan when
the motor is running.
11. Incasethechokeleverwasclosedwhenstarting(CLOSED
position),youshouldnowplaceitintheOPENposition.
12. Place your foot on the gas pedal and press it forward in order
to drive forward.
Press the gas pedal backward in order to drive backward.
Takeyourfootothegaspedalinordertobrake.
i
The speed is not regulated via the gas pedal. In order
to speed up or slow down you must adjust the gas
lever on the motor appropriately.
Attention
Running machine at wide open is not advised and
may overheat components.
Shut down and Dismounting:
NEVER dismount unit with the engine running.
1. Takeyourfootothegaspedal.
2. Move throttle to idle position.
3. Turnignitionkeytooposition.
4. Make sure that the PowrDriver has come to a complete stop,
donotgetobeforethisisthecase.
i
The PowerDriver’s seat is equipped with a sensor.
This sensor shuts o the motor automatically, as
soon as the driver gets o.
5. Turnothefanwiththetoggleswitch.
i
Always turn o the fan when the motor is turned o,
since it otherwise will run down the battery.
Maintenance
Read below in order to know what type of maintenance should be
performed on your PowrDriver at certain intervals of usage.
i
For detailed information about maintenance and
care of the motor, please read the instructions in the
operation manual for Honda motors.
Daily:
• Checkengineoillevelandllasnecessary.
• Checkhydraulicoiltransmissionreservoirlevelandllas
necessary.
• Checkandllthegastankwithregularunleadedgas.
• Checktiresandinateto1,7bar(25PSI)ifneeded
• Wipedownequipment–Neveruseawaterhosetowash.
• Checkandcleanaircleaner.Replacewhennecessary
After rst 20 hours:
• DrainandrellengineoilwithSAE10W-30oil.See
manufacturers specs for API rating.
Weekly:
• Addasmallamountofgreasetoballcouplerinsideballarea.
• Checkallhardwareforintegrity.Tightenanylooseboltsor
nuts.
Every 50 hours:
• Replacesparkplug
• Inspectsystemforoilleakagefromdriveassembly.
Every 100 hours:
• Spraythechainwithdrychainsprayformotorcycles.
• GreaseAxleBearings–Molytypegrease,twopumpsofgrease
gun.Wipeexcessgreaseobearings.
• DrainandrellengineoilwithSAE10W-30oil.See
manufacturers specs for API rating
• CheckandrellifnecessaryTransmissionreservoir.
• CheckChaintensionandresetidlersprockettotensionif
required.Removetransmissioncoverandcheckdrivebelt.
Re-tensionifrequired.
• Useairsupplytoremoveaccumulateddustinsidecover.
 previous next