Filter
Top Products
English
18
Cleanup -
Oil-Based
Materials
Start
You will need:
• Mineral spirits if using oil-based material
• Warm, soapy water if using latex material
• Waste container
Follow these steps if you sprayed oil-based
materials,orifyousprayedlatexmaterials
and do not have a garden hose available.
Be sure to use the appropriate cleaning
solution for the type of material sprayed.
1. Perform Pressure Relief
Procedure (page 7).
5. While squeezing the
trigger, turn the power
ON, and turn the PRIME/
SPRAY knob to SPRAY.
4. Start the engine (see instructions
on page 4).
Point the spray gun at the side of
a waste container.
Ground the gun against the
side of a metal waste container
ifushingwithmineralspirits.
2. Remove the spray tip
and place into an empty
waste container.
6. Continue squeezing the trigger
until uid is coming out clear.
You may need to get new
cleaning solution.
3. Attach the supplied grounding wire
to a grounded object.
Submerge suction set into a
bucket with the appropriate
cleaning solution.
7. Perform Pressure Relief
Procedure, page 7.
Ifyouushedthesprayerwithmineral
spirits repeat the steps on this page
using warm, soapy water.
SPRAY
PRIME
1 2 3
SPRAY
PRIME
54 6
SPRAY
PRIME
7