Filter
Top Products
English
19
Cleaning the
Spray Gun
Components
Start
You will need:
• Soft bristled brush
• Light household oil
• Warm, soapy water if using latex material
• Mineral spirits for oil based material
• Wrench
IMPORTANT: DO NOT use any silicone-
based lubricants to clean or lubricate the
spray gun.
1. Peform the Pressure
Relief Procedure, page 7.
5. Install gun lter tapered-
end rst. Reassemble
spray gun.
4. Pour a few drops of light
household oil inside gun
housing.
2. Pull trigger guard to separate
from lter housing and unscrew
housing using a wrench.
Note: Tighten the wrench over the
wrench ats (a).
6. Line up the tabs (b) on the
spray tip with the slots in the
guard assembly.
Slide the tip into the guard.
3. Remove lter from spray gun.
Clean spray tip and lter with soft
bristled brush and appropriate
cleaning solution.
7. Install spray tip and guard
assembly.
Move on to Long Term
Storage, page 20.
SPRAY
PRIME
1
54
(a)
(b)
(c)
2
6
3
7
HOUSEHOLD
OIL