Filter
Top Products
GB
29
Flexio 580 I-Spray
Turn the air quantity regulator (g. 9.1) to the required position.
thin paint
Level I
thick paint (e.g. interior wall paint)
Level II
15. Spray Technique
i
The spray result depends heavily on the smoothness and cleanliness of the
surface to be sprayed. Therefore the surface should be carefully prepared and
kept free of dust.
Cover all surfaces not to be sprayed.
•
Cover screw threads or similar parts of the target object.
•
i
Important: Start at the edge of the area to be sprayed. Start the spray
movement rst of all, and then press the trigger. Avoid interruptions
within the area to be sprayed.
The spray movement should come from the arm, not just from the wrist. This ensures that
•
a uniform distance is maintained between the spray gun and the spray surface during
the spray operation. Select a distance of 5 - 15 cm, depending on the desired spray jet
width. When you are using interior wall paint, the distance should be about 20-30 cm.
Fig. 10 A/ 10 B: CORRECT Even distance to the object.
Fig. 10 B:
INCORRECT An uneven distance will result in uneven paint
application.
Move the spray gun evenly cross-wise or up-and-down, depending on the spray
•
pattern setting.
An even movement of the spray gun results in an even surface quality.
•
i
Important: Wipe o the nozzle and air cap regularly
to make sure they do not get blocked.
i
"Cross spray" when using paint with a poor covering capacity or if the
surface is highly absorbent (Fig. 11).
Interior wall paint in strong colour shades should be applied at least twice (allow rst
•
paint coat to dry rst). This will ensure good coverage.
16. Interruption of Work
Turn the machine o.
•
During longer breaks, vent the container by briey opening and then closing it again.
•