Filter
Top Products
GB
35
Flexio 580 I-Spray
Problem Cause Remedy
Atomisation too
coarse
Coating material too thick
•
Material volume too large
•
Material volume adjusting screw
turned too far to the right (+)
Nozzle contaminated
•
Air lter heavily soiled
•
Too little pressure build-up in
•
container
Amount of air too low
•
Dilute ➞
Turn material volume ➞
adjusting screw to the
left (-)
Clean ➞
Change ➞
Tighten container ➞
Increase air quantity ➞
(Level II)
Spray jet pulsates Coating material in container
•
running out
Air lter heavily soiled
•
Nozzle seal is missing or worn
•
Rell ➞
Change ➞
Insert an intact nozzle ➞
seal
Coating material
causes "paint tears"
Too much coating material
•
applied.
Turn material volume ➞
adjusting screw to the
left (-)
Too much fog of
coating material
(Overspray)
Distance to the object too large
•
Too much coating material
•
applied
Amount of air too high
•
Reduce distance ➞
Turn material volume ➞
adjusting screw to the
left (-)
Decrease air quantity ➞
(Level I)
Paint in the
ventilating hose
Diaphragm soiled
•
Diaphragm defective
•
Clean the diaphragm ➞
Replace the diaphragm ➞
Poor covering
capacity on the wall
Spray material is too cold
•
Highly absorbent surface or paint
•
with poor covering capacity
Distance too large
•
The material you are ➞
spraying should be at
room temperature
Cross spray (Fig. 11) ➞
Closer to the object ➞
Device does not
function
Device overheated
•
Unplug the power ➞
plug, let the device
cool down approx. 30
minutes, check the air
lter, do not cover the
intake slots