Woods Equipment VR48A Power Roller User Manual


 
Owner Service 13
MAN0357 (Rev. 12/10/2007)
Figure 11. Remove Spring Retaining Ring
4. Firmly grasp the top of the shaft and pull assembly
from motor.
5. Remove snap ring (Figure 12) from the shaft and
slide spacer and bearing from shaft. Save snap
ring and spacer for later use.
Figure 12. Remove Snap Ring
6. Inspect shaft for cracks, grooves, nicks, or bumps.
Resurface any damage with emery cloth or replace
shaft.
7. Using a puller (Figure 13) or screwdriver, remove
seal from motor housing.
NOTE: Do not scratch or gouge motor surface
when removing seal.
Figure 13. Seal Removal
Install Seal and Bearing
1. Clean area in housing where seal outer diameter
(OD) seats. Apply a thin coat of Permatex®.
2. Inspect area of shaft where seal seats. Remove
any burrs or nicks with an emery cloth.
3. Place seal squarely on housing, place spring-
loaded lip down towards housing. Select a piece of
pipe or tubing with an OD that will sit on the outside
edge of the seal but will clear the housing. Tubing
with an OD that is too small will bow seal cage and
ruin seal.
4. Carefully press seal into housing, avoiding
distortion to the metal seal cage.
5. Slide bearing and spacer washer onto shaft and
secure with snap ring.
6. Insert shaft into motor housing and align splines.
7. Install spring retaining ring to secure shaft into
motor housing.
Figure 14. Spring Retaining Ring
8. Attach motor to roller using hardware previously
removed. Connect hydraulic hoses.
DP11
Spring
Retaining
Ring
Snap
Ring
DP12
DP13
Spring Retaining
Ring Installed
DP14