Filter
Top Products
Accessing Charger Information
975-0401-01-01 2–15
There is only ONE way to safely turn the Truecharge™ 2
Battery Charger off (Disable):
◆ Disconnect the AC power at the source and disconnect all
DC batteries.
This is the only state where the Truecharge™ 2 Battery
Charger is completely de-energized.
When the Truecharge™ 2 Battery Charger is disabled, the
optional remote panel is inactive.
Accessing Charger Information
The Truecharge™ 2 Battery Charger provides a lot of
information about the status of the charger and the batteries.
Reading Remote Panel and Onboard Display LEDs
The remote panel and onboard display panel show what is
happening during the charging process and are also helpful in
troubleshooting. Refer to Chapter 3, “Interpreting Fault and
Warning Indicators” on page 3–4 for information about
interpreting the onboard display panel (and the optional
remote panel, if installed) indicator LEDs.
Reporting While Charging or Equalizing
After configuring the charger and during charging, the
onboard display panel (and the optional remote panel, if
installed) will show the following information about the
charger and the battery:
• Charging Output Current
• Charger Status
• Battery Status (optional Remote Panel only)
If there is a fault or warning related to one of the banks, the
fault or warning information will display in the form of
illuminating or flashing Fault indicator LEDs. Charging for
all banks will stop and will only resume once the fault
condition is cleared.