Xantrex Technology TC10 Battery Charger User Manual


 
10
The first two conditions ensure that the Truecharge 10 keeps your battery
“topped up” if it is left permanently connected. The last two conditions
ensure that the Truecharge 10 starts in a predictable fashion after you
disconnect the battery or the AC power.
WARNING! To reduce the risk of sparking and damage to your
Truecharge 10, always disconnect AC power from your Truecharge 10
before connecting or disconnecting the battery or batteries.
Important Safety Instructions
SAVE THESE INSTRUCTIONS. This manual contains important safety
and operating instructions for the Truecharge 10 battery charger.
Do not expose charger to rain, snow, or spray.
Use of attachments not recommended or sold by the battery charger
manufacturer may result in a risk of fire, electric shock, or injury to
persons.
To reduce risk of damage to electric plug and cord, pull by plug
rather than cord when disconnecting charger.
An extension cord should not be used unless absolutely necessary.
Use of improper extension cord could result in a risk of fire and
electric shock. If an extension cord must be used, make sure:
a) That pins on plug of extension cord are the same number, size
and shape as those of plug on charger.
b) That extension cord is properly wired and in good electrical
condition, and
c) That wire size is 18 AWG (0.8 mm
2
) or larger and cord is less
than 100 feet (30 m) long.
Do not operate charger with damaged cord or plug. Replace the cord
or plug immediately.
Do not operate the charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. If the charger is dam-
aged, take it to a qualified service person.
Do not disassemble the charger. Take it to a qualified service person
when service or repair is required. Incorrect reassembly may result in
a risk of electrical shock or fire.
To reduce risk of electrical shock, disconnect power from the charger