Filter
Top Products
16
■ STARTING ENGINE
•Before starting the engine, check if there is
any problem such as loose fitting of cutter
blade or fuel leakages.
•Place the machine on the ground and hold
securely when starting. Do not start the
engine while hanging it by one hand because
the cutter blade may contact with the ground
or other obstacles.
• As the engine starts with throttle lever locked
in a starting position, the cutter blade starts
to turn at the same time. Avoid the cutter
blade from contacting the ground and keep
surrounding obstacles away.
• Confirm if the cutter blade stops to turn
when the throttle lever is fully retarded. In
case the blade continues to turn, stop the
operation and adjust or maintain to the
proper operation.
• To avoid accidents, do not lock the throttle
lever during operation.
• Be sure to hold the handle by both hands
during operation. Left hand shall always hold
a front handle with the thumb downward.
Continuous high speed idling will apply extra load
to the engine. Release the throttle lever when
cutting operation is not continued. Especially
during a running-in period, avoid high speed idling
as the engine is exposed to a heavy load.
1. Apply fuel in a tank and secure a cap. (OP1)
(1) Fuel inlet (2) Fuel tank cap
2. Power switch to ON position.
3. Pull a choke knob on rear right side of the
machine for choke closing. (OP2)
(1) Switch (2) Choke knob
(3) OPEN (4) CLOSE
IMPORTANT
WARNING
8. Operation
OP1
OP2