Filter
Top Products
19
8. Operation
■ CUTTING OPERATION
• For cutting, hold the machine in your body
centre and lead the dust hose through both legs.
Lightly bend the knees and keep a stable
posture.
•When applying the cutter blade to a work, start
with low speed to form a guide notch, and then
cut with full throttle.
Do not forcedly press the cutter blade during
cutting. It may end up with quick wear of blade or
troubles on a drive mechanism.
■ FOR AN EFFICIENT CUTTING OPERATION
• In case the front guide tip is not contacting a
work, capture of dusts becomes insufficient
and its dust collection performance is
spoiled.
•A front guide under the blade cover can slide.
For cutting operation, press the front guide tip
onto a work.
• Dusts are sucked from the front guide tip and
collected in a dust bag after passing through
inside of the blade cover, a dust collection fan
and the dust hose.
• The dust collection performance is dependable
to cutting direction. Before stating the operation,
refer (OP7) and decide a cutting direction so that
dusts are efficiently collected thorough the front
guide
• Dust collection performance is spoiled if the
dust bag is full with dusts or clogged with
water.
• At least once in every day, remove the dusts in
the dust bag by opening the fastener. In case
the bag is wet with water, dry it thoroughly for
next use.
(1) Front guide
(A) Horizontal Cutting
Move cutter back from forward.
(B) Vertical Cutting
Move cutter downward.
IMPORTANT
OP7
OP6