3 - 16 ONline Ethernet 10BASE-FL Installation and Operation Guide
To enable RFS for a port, issue the following management command:
SET PORT {
slot.port
} MODE REMOTE_FAILURE_SIGNALING
Saving Module Configuration
To save the module and port settings to management module memory,
issue the following command:
SAVE MODULE_PORT
Showing Module Configuration
You can display status information about the 10BASE-FL Module using the
following commands:
❑ SHOW MODULE
❑ SHOW MODULE VERBOSE
❑ SHOW PORT
❑ SHOW PORT VERBOSE
For example, the following command displays detailed information about
port 1 on an 10BASE-FL Module in slot 6 of the concentrator.
ONline> show port 6.1 verbose [ENTER]
Port Display for Module 5104M-FL
Port Mode Status Network General Information
06.01 ENABLED OKAY ISOLATED
Port Connector FIBER
Mode Dip Setting: ENABLED
