Software Flow control
C-3
Software Flow
control
The table below lists the Software flow control template. To load this
template send
AT&F2
to the modem.
.
NVRAM Options Setting Description
Handshake option B0 ITU-T answer sequence
Transmitter C1 Enabled
Command mode echo E1 Enabled
Online local echo F1 Disabled
Training tone volume L2 Medium
Speaker control M1 ON during dial through connect
Result codes Q0 Enabled
Verbal or numeric
result codes
V1 Verbal result codes
Result code subset
X7 Extended. Includes all codes except
VOICE
Protocol response
codes
&A3 Full protocol codes
Serial port rate select &B1 Serial port rate fixed higher than connect
rate
Carrier Detect &C1 Normal operations
Guard tone &G0 U.S./Canada
Transmit data
hardware flow control
&H2 Software flow control
Record data software
flow control
&I2 Enabled
Analog data
compression
&K1 Enabled
Normal lines &L0 Normal lines
Error control &M4 Normal/error control
Link rate select &N0 Variable
Pulse dialing typE &P0 U.S./Canada
Record data hardware
flow control
&R2 Enabled
Data Set Ready &S0 Always on
Remote Digital
Loopback (RDL)
&T5 Deny RDL
Break handling &Y1 Clear buffer, send immediately
