Accessing the Host
9-3
Other Remote-Access
Commands
The table below is a list of remote-access configuration commands.
Example:
Sending
AT%P1=
will erase the view and change password.
WARNING:
If you erase the%P1 password without disabling remote
access (using
ATS41=0
), anyone could access the Business Modem and
change its configuration.
Accessing the Host
At the Guest Device
The guest device requires no configuration to access the host. Follow
these steps:
1
Be sure that the host device has enabled remote access and is set to
auto-answer (
ATS0=1
). Know the password, if you will need one.
2
Call the host device (although it doesn’t matter which device originates
the call).
3
After a connection is established, do this:
a
Pause 4 seconds.
b
Type 4 tildes: ~~~~
c
Pause 4 seconds.
The administrator of the host device can change the remote-access
character using S-Register 42, and the pause duration using S-Register
43. See Appendix A,
S-Registers
for more information.
For your modem to Command
Display a view-only password
AT%P0?
Display a view-and-change password
AT%P1?
Erase a view-only password
AT%P0=
Erase a view-and-change password
AT%P1=
Disable remote access entirely
ATS41=0
