CLI Commands B-33
■
bridging [enable | disable]
■ default_route_option [enable | disable]
■ destination_address [ip address]
■
■
end_time [ HH:MM:SS ]
■ header_compression [none | TCPIP]
■ idle_timeout [seconds]
■ input_filter [filter_name]
■ ip [enable | disable]
■ ip_routing [listen | send | both | none]
■ ip_source_validation [enable | disable]
■ ipx [ enable | disable ]
■ ipx_address [ ipx_addr ]
■ ipx_routing [ all | listen | respond | send | none ]
■ ipx_wan [ enabled | disabled ]
■ local_IP_address [ip_net_address]
■ mac_routing [enable | disable]
■ MTU [number]
■ NAT_option [disable | enable]
■ NAT_default_address [ip_addr]
■ network_service [ppp | PPPLLC | RFC_1483]
■ output_filter [filter_name]
■ password [ password ]
■ remote_ip_address [ip_addr]
■ rip [ripv1 | ripv2]
■ rip_authentication [string]
■ rip_policies_update [rip_policies]
■ send_name [ ]
■ send_password [“text string”]
■ type [ONDEMAND | CONTINUOUS | MANUAL]
Specifies parameters for VCs.
Parameters Description
<vc_name> VC profile name.
address_
selection
Determines how the IP address will be assigned for remote IP network
connections.
NEGOTIATE - learn the remote IP address.
SPECIFIED - uses IP address set in remote_IP_address value
bridging Enables/disables bridging across this link.
