CLI Commands B-19
■ Type - interface type: Ethernet or Token Ring
■ If Name - eth:1, DA:1 or loopback
list ip interface_block Displays the IP addresses associated with each system interface. If the interface has
a point-to-point connection, then the neighbor field contains the address of the
remote system. This command lists:
■ Address - IP address of the interface
■ Neighbor - IP address of the remote system
■ Status - status of the connection; ENABLED or DISABLED
■ Interface - eth:1, DA:1 or loopback
list ip networks Displays all the IP networks you previously defined using the add ip network
command. It also lists:
■ Name - network designation
■ Prot - always the IP protocol
■ Int - name of the interface this network runs on
■ State - state of the network; ENABLED or DISABLED
■ Type - STATIC or DYNAMIC network
■ Network Address - address of the IP network
list ip routes Displays all the statically defined IP routes that you previously defined using the
add ip route command. It lists:
■ Destination - IP address that the route resolves to
■ Prot - LOCAL or RIP
■ NextHop - address of the gateway used to reach this route
■ Metric - number of router hops away this route is from the system
■ If - interface that the route uses
list ipx networks Displays the IPX networks that you previously defined using the add ipx network
command. It lists:
■ Name - designation you assigned this network
■ Prot - protocol; always IPX
■ Int - interface each IPX network runs on
■ State - ENABLED or DISABLED
■ Type - STATIC or DYNAMIC
■ Network Address - network address of this IPX network
list ipx routes Displays the IPX routes that you previously defined using the add ipx route
command, plus the defined IPX nodes. It lists:
■ Network Addr - network address of this route
■ Prot - protocol used to find this route: LOCAL, RIP, STATIC, NLSP, OTHER
