3M™ Multimedia Projector S55/X45/X55 Product Safety Guide© 3M 2004 7
WARNING
(continued)
• To reduce the risk associated with the hot surface temperatures produced by
the projection lamp, which if not avoided may result in death or serious injury:
- Never touch the projection lamp or surrounding surfaces while the lamp is still hot.
- Switch projector “OFF”, remove the power cord from the electrical outlet, and
allow the unit to cool for at least 45 minutes before replacing the lamp.
• To reduce the risk associated with air or ground water contamination, which if
not avoided could result in death or serious injury:
- The lamp in this product contains mercuy. Dispose of projection lamp in a manner
that is consistent with your local hazardous waste regulations for mercury.
- For recycling and disposal information, contact your respective governmental
agencies.
In U.S., contact the Electronic Industries Alliance at
www.lamprecycle.org
In Canada, contact the Electronic Product Stewardship Canada at
www.epsc.ca
CAUTION
• To reduce the risks associated with fire, explosion, chemical leakage, and/or
poisoning, which if not avoided may result in minor or moderate injury and/or
property damage:
- Use only the specified batteries with this remote control transmitter.
- Never mix old and new batteries.
- Use care to orient the plus (+) and minus (-) terminals of the batteries according to
the markings found on the remote control.
- Use and handle batteries in a manner that avoids damaging them.
- Keep batteries away from children and pets.
- Remove the batteries from the remote control when not to be used for an
extended period.
• To reduce the risk associated with air or ground water contamination, which if
not avoided may result in minor or moderate injury:
- Dispose of batteries in a manner that is consistent with your local hazardous
waste regulations.
• To reduce the various risks associated with this product, which if not avoided
may result in minor or moderate injury and/or property damage:
- Do not expose this projector to direct sunlight, or use it outdoors.
- Always operate the unit on a flat, sturdy, and horizontal surface.
-
Never operate the unit in a vertical orientation such that the lens points up or down.
- Do not insert liquids or foreign object. To avoid penetration of foreign objects, do
not put the projector into a case or bag together with anything except the
accessories of projector, signal cables and connectors.
ENGLISH
