Chapter 4 Avaya P460 Layer 2 Features
LAG CLI Commands
In order to... Use the following command...
Enable or disable a Link
Aggregation Group interface on the
switch
set port channel
Display Link Aggregation Group
information for a specific switch or
port
show port channel
LAG Configuration Example
This example shows definition of a LAG called “p460lag” using ports 41 to 47 on
I/O module 6:
P460-1(super)# set port channel 6/41-47 on p460lag
Port 6/41 channel mode set to on
Port 6/42 was added to channel
Port 6/43 was added to channel
Port 6/44 was added to channel
Port 6/45 was added to channel
Port 6/46 was added to channel
Port 6/47 was added to channel
L Port 41 is the base port
30 Avaya P460 Configuration Guide
