A SERVICE OF

logo

Open as PDF
next previous
Preparing and Installing the 9A426-02 Module
2-16
2. Attach one end of the ESD wrist strap packaged with the SmartSwitch 9000
chassis to your wrist. Plug the other end into the ESD Wrist Strap Grounding
receptacle in the lower right corner of the SmartSwitch 9000 Chassis shown in
Figure 2-11.
3. Grasp the module and slide it into the slot.
Make sure that the module’s circuit card is between the card guides, as shown
in Figure 2-11. Check both the upper and lower tracks of the card. Take care
that the module slides in straight and engages the backplane connectors
properly.
4. Lock down the top and bottom plastic tabs, as shown in Figure 2-11.