121
Special Recording Modes
English
3 Press the START/STOP button to begin recording.
• The front and rear tally lamps illuminate.
• [S&F STBY] changes to [ÜS&F REC] while recording.
4 Press the START/STOP button again to stop recording.
• The clip is recorded at the selected frame rate.
• The tally lamps go out and [S&F STBY] appears at the top of the screen.
NOTES
• Slow & fast motion recording cannot be used together with other special recording modes or double slot
recording.
• The shooting frame rate cannot be changed while recording.
• For lower shooting frame rates, it may take approximately 1 second to stop recording.
• Slow & fast motion mode will be deactivated if the special recording mode is changed or turned off. It will be
deactivated also if you change the movie format or video configuration.
• When the bit rate is set to 50 Mbps (A 55), relay recording is not available during slow motion recording.
• During this special recording mode, the time code’s running mode (A 90) can be set to [Rec Run] or [Regen.]
and the time code advances by the number of frames recorded. If the time code’s running mode is set to [Free
Run] or the time code is input from an external source, the running mode will switch to [Rec Run] during
special recording mode. When the special recording mode is deactivated, the running mode will return to its
previous setting.
• During special recording mode, the time code signal will not be output from the TIME CODE terminal,
3G/HD-SDI terminal or MON. terminal.
Pre-recording Mode
When pre-recording mode is activated, the camcorder starts recording
continuously into a temporary memory of approximately 3 seconds so
when you press the START/STOP button, the clip will contain also
approximately 3 seconds of video and audio recorded before you pressed
the button.
1 Open the [Special Recording] submenu.
[w Other Functions] > [Special Recording]
2 Select [Pre-Recording] and then press SET.
• [PRE REC STBY] appears at the top of the screen.
3 Press the START/STOP button to begin recording.
• The front and rear tally lamps illuminate.
• [PRE REC STBY] changes to [Ü PRE REC] while recording.
Operating modes:
Shooting frame rate
Playback frame rate
[w Other Functions]
[Special Recording]
[Off]
C OPY
