Recording Video
56
IMPORTANT
• Observe the following precautions while the CF2 or CF3 access indicator is illuminated in red. Failure to do
so may result in permanent data loss.
- Do not open the CF card slot cover of the CF card slot being accessed and remove the CF card.
- Do not disconnect the power source or turn off the camera.
• Be sure to save your recordings regularly (A 152), especially after making important recordings. Canon shall
not be liable for any loss or corruption of data.
NOTES
• By default, [ 4K/2K/MXF Setup] > [Rec Command] is set to [On]. With this function, when you connect the
camera to another device using the 3G-SDI terminals (in 4K and 2K modes) or HD/SD SDI terminal (in MXF
mode), if you start or stop recording with the camera, the other device will also start or stop recording.
•By default, [w Other Functions] > [Fan] is set to [On] and the internal cooling fan will be activated at all times.
You can also set the fan to activate when the camera’s internal temperature has risen to a predetermined level.
• When recording MXF clips, the following apply.
- You can use [w Other Functions] > [Rec Review] (A 104) to review part or all of the last clip recorded.
- If you set an assignable button to [Add $ Mark] or [Add % Mark] (A 111), you can press the button to
add an $ mark or % mark to the last clip recorded.
- You can use [w Other Functions] > [Delete Last Clip] (A 175) to delete the last clip recorded. However,
you cannot delete the last clip if double slot recording is on.
