56
NETWORK Menu
MENU [RGB]
IMAGE
SETUP
PICTURE
INPUT
OPTION
EASY MENU
SCREEN
:SELECT
NETWORK
IP ADDRESS
SUBNET MASK
DATE AND TIME
DHCP
TURN OFF
DEFAULT GATEWAY
TIME DIFFERENCE
e‑SHOT
INFORMATION
Multifunctional settings
Item Operation
DHCP
(Dynamic Host
Configuration
Protocol)
DHCP TURN ON/TURN OFF:
Use the ▲/▼ buttons to turn DHCP on/off
TURN ON
TURN OFF
Select TURN OFF when the network does not have DHCP
enabled.
IP ADDRESS
Entering the IP ADDRESS :
Use the ▲/▼/◄/► buttons to enter the IP
ADDRESS. This function can only be used
when DHCP is set to “TURN OFF”.
~Note~
The IP ADDRESS is the number that identifies this projector on the
network. You cannot have two devices with the same IP ADDRESS
on the same network.
SUBNET MASK
Entering the SUBNET MASK :
Use the buttons ▲/▼/◄/► to enter the
same SUBNET MASK used by your PC.
This function can only be used when DHCP
is set to “TURN OFF”.
Select [Network]
from the main menu to access the following
functions.
NOTE
• The factory default setting for DHCP is “TURN ON”. There is no need to set
up [DHCP], [IP ADDRESS], [SUBNET MASK] or [DEFAULT GATEWAY] if your network
has DHCP enabled.
(
User’s Manual - Network Functions)
• If you are not utilizing SNTP (
User’s Manual - Network Functions), then you must
set the DATE AND TIME during the initial installation. Please refer to the item DATE AND
TIME on the following list.
NOTE Consult with your network administrator before connecting to an existing
access point on your network. Incorrect network settings on this projector may cause
trouble on the network.
192. 168. 254
IP ADDRESS
1.
255. 255. 0
SUBNET MASK
255.
8755D-RJ only! (LAN)
