Configuring AutoShade
If you have AutoShade, the first time you use it with the driver,
you need to configure AutoShade for an ADI display. Follow
the steps below:
1.
Before you run the AutoShade program, remove the file
SHADE.CFG from the AutoCAD directory on your hard
disk. (You can use the DEL or ERASE command; see your
MS-DOS Reference Manual.)
2. Start AutoShade.
3.
The program asks for a display and rendering driver. Select
ADI
for both drivers and indicate that you have a dual
display system.
4.
When you exit from the AutoShade program, it creates a
new SHADE.CFG file.
Digital Research GEM, Version 2.2
Epson provides drivers for GEM for the following resolutions:
LI
640 x 480 16-color graphics
CI
800 x 600 16-color graphics.
Installing the Drivers
Follow the steps below to install the display drivers. If you have
already installed GEM 2.2 on your computer, go to step 2 to
install the GEM driver. If you have not yet installed GEM 2.2,
begin with step 1.
A-16
Using the VGA Utilities
