Tools Needed: Qty
Upper and Lower Guide Bearing
Adjustment
1.
2.
3.
Figure 34
Adjusting Blade
Guides
Figure 34.
Note: In most cases, the only adjustment
necessary is to adjust the guide bearing
eccentric spindles. This adjustment is out-
lined in Steps 4–6 below. If the proper posi-
tioning cannot be accomplished by turning
the eccentric spindles, you must re-position
the lower and upper blade guide assemblies,
as outlined later in this section.
4. Figure 35
5.
Figure 36
6.
7. Steps 46
Figure 35.
IDEK>:L;GDCIK>:L
IDDADDH:IDDI><=I
8DGG:8I
>C8DGG:8I
Figure 36.
