42
Turning On the AV Receiver
Standby/On
On
Receiver
Standby
Standby indicator
Turning On and Standby
1
Press the [Standby/On] button.
Alternatively, press the remote controller’s [Receiver] button, followed by
the [On] button.
The AV receiver comes on, the display lights up, and the Standby indicator goes off.
Pressing the remote controller’s [On] button again will turn on any components con-
nected via .
To turn the AV receiver off, press the [Standby/On] button, or press the remote control-
ler’s [Standby] button. The AV receiver will enter Standby mode. To prevent any loud
surprises when you turn on the AV receiver, always turn down the volume before you
turn it off.
Receiver
On
or
emo
e
controllerAV receiver
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See “Automatic Speaker Setup (Audyssey MultEQ XT)” on page 52.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see “HDMI Input Setup” on page 46, “Component Video
Setup” on page 47, or “Digital Input Setup” on page 49 respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see “Changing the Input Display” on page 48.
HDMI
OUT IN
TAPE
CD recorder, MD recorder,
RI Dock
DTR-6.8_En.book Page 42 Wednesday, June 20, 2007 4:16 PM
