67
Using a Macro function
Erasing all commands and macros that have
been programmed
This procedure will erase all the commands and
macros that you have programmed into the remote
controller and return it to its default settings. This
operation will not affect the preset settings of the
remote controller.
1. Open the battery cover and remove the
batteries from the remote controller.
2. While pressing and holding down the POWER
ON and POWER STNBY buttons, re-insert the
batteries in their correct orientation, and then
release both buttons.
The SEND/LEARN indicator flashes slowly and
“CLEAR” appears in the display.
3. Press the ENT button.
The SEND/LEARN indicator lights up for about ten
seconds and then turns off and “AUDIO” appears in
the display.
All programmed commands and macros are erased
and the remote controller returns to its factory presets.
Notes:
• Proceed to Step 3 immediately after Step 2; other-
wise, the batteries will be consumed quickly.
• If you press any button other than the ENT button in
Step 3, nothing will be erased. In this case, resume
from Step 1.
OPEN/COLSEREC
AUDIO MUTING
DISCTRACK
DVD
CD
PH
TUN
T2T1
V1
STEREO
123
654
7
+
10 0
ENT
89
SURROUND THX DSP
LEVEL
+
CH SELRe-EQ
LEVEL
–
DIMMERLATE NIGHT
DIRECT DSP
V2 V3 V
–
POWER ON
POWER STNBY
ENT
HOME THEATER CONTROLLER
RC-418M
MACRO
Operation 1
Operation 2
Operation 3
Operation 4
Operation 5
Operation 6
Operation 7
Operation 8
Operation 9
Operation 10
Operation 11
Operation 12
Operation 13
Operation 14
Operation 15
Operation 16
MODE
MACRO
↓
AUDIO
MODE
MACRO
↓
CD
MODE
MACRO
↓
DVD
MODE
MACRO
↓
MD
MODE
MACRO
↓
SAT
MODE
MACRO
↓
CABLE
MODE
MACRO
↓
VCR
MODE
MACRO
↓
TV
DIRECT
MACRO
Macro mode programming memo:
