2-34 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
•
Apply oil to the sides of the rollers so that oil will penetrate
to the rollers and bushings. Apply the oil to the O-rings so
that th
e O-rings will be coated with oil.
•
Wipe off any excess oil.
Oil Applied Areas [A]
O-ring
[B]
Brakes
Brake Pad Wear Inspection
•
Check the lining thickness [A] of the pads in each caliper.
If the lining thickness of either pad is less than the service
limit [B], replace both pads in the caliper as a set.
Pad Lining Thickness
Standard:
Front
4 mm (0.16 in.)
Rear
5 mm (0.20 in.)
Service Limit: 1 mm (0.04 in.)
Rear Brake Light Switch Inspection/Adjustment
•
Turn on the ignition switch.
•
Check the operation of the rear brake light switch by de-
pressing the brake pedal. The brake light should go on
after about 10 mm (0.39 in.) of the pedal travel [A].
