J
_,_,_ SECTION 4 _IKNOW ABOUT YOUR WATER SOFTENER
A. DIMENSIONS / SPECIFICATIONS
24
Pressure Drop (PSI) vs. Flow Rate (GPM)
21
_18
o=.15
12
==
.o
o. 6
3
0
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
Flow Rate (GPM)
OTHER SPECIFICATIONS
Type of ion exchange material (resin) - -
Amount of resin (cu It) ...............
Regeneration (recharge) cycle times (minutes)
Fill (NaCL setting) ...............
Fill (KCI setting).................
Brining / brine rinse .............
Backwash .....................
Fast rinse ......................
Total regeneration time © ..........
Efficiency Bating (gr/Ib at 3.1 [bsalt
dose) .............................
Max. Drain Flow Rate (gpm) ..........
high capacity
1.06
3.6 - 11.5
I
4.5 - 14,4 !
120 - 135
3
133.6 - 159.4
gpm = gallons per minute
psi = pounds per square inch
gpg = grains per gallon
ppm = parts per million
_) Does not include CLEAN feature cycle times if set to
ON.
This system conforms to ANSI/NSF 44 for the specific
performance claims as verified and substantiated by test
data.
The efficiency rating is only valid at the stated salt dose.
These softeners were efficiency rated according to ANSI/
NSF Standard 44.
4-2
Problems, Questions ? Call 1- 800- 426- 9345 Kenmore Water Line
